![]() Install ffmpeg: sudo apt install ffmpeg.Edit sudo nano /etc/modules and add the line bcm2835-v4l2. ![]() ![]() Those instructions also indicate that avahi must be installed: sudo apt-get install libavahi-compat-libdnssd-devįinally, we can actually install homebridge: sudo npm install -g homebridgeĪs well as homebridge-pi (which will provide thermal measurements from the Pi in Homekit): sudo npm install -g homebridge-piīefore installing homebridge-camera-rpi (which will expose the camera to Homekit), we need to: This command will install the most recent LTS version of node.js by running a script from node-pi-zero: wget -O - | bashįrom Running Homebridge on a Raspberry Pi, Homebridge will require git to be installed: sudo apt-get install git Homebridge requires an installation of node.js, which, surprisingly, can’t be installed via apt on the Pi Zero. Install Homebridge, homebridge-pi, and homebridge-camera-rpi I selected my time zone and set the locale to en_us.UTF-8 via sudo raspi-config.įinally, I updated the software with: sudo apt-get update.Then I inserted the SD card in the Pi, booted it up, found it’s IP address on my network (I used LanScan), and connected via ssh It’s important to change the pi account password with the passwd command. The contents should be: country=USĬtrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev To allow the Pi onto my home network, I created a file named wpa_nf at the root of the SD card. I enabled ssh access by creating an empty file named ssh at the root of the SD card.Using balenaEtcher, I installed the September 2019 version of Raspbian Buster Lite (link to latest release) on my SD card.These are the steps I took to configure it with Homebridge as a Homekit-compatible camera. I finally started over from scratch with my Raspberry Pi Zero W and Camera Module V2.
0 Comments
Leave a Reply. |